|
Thank you, from the BaitShop Boyz! |
Aluminum boat metal guage |
Post Reply 
|
| Author | |
gary murray 
.416 Rigby 
Joined: 13 February 2005 Location: Canada Status: Offline Points: 1603 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Aluminum boat metal guagePosted: 14 September 2005 at 01:12 |
|
I should of added this question in with my other post so i apologize. Like i said earlier, i plan on putting two patches on my boat and i need to know what thickness or guage the metal patches have to be. I was thinking 1/16 but im not sure. Can i use galvanized instead of aluminum if need be? Gary |
|
|
If you can sue McDonalds for getting you fat then why can't you sue the alcohol companies for all the ugly people you ended up sleeping with?
Penticton, B.C. Canada |
|
 |
|
|
Guests
Guest 
|
Post Options
Thanks(0)
Quote Reply
Posted: 14 September 2005 at 04:01 |
|
No galvanized, no steel. Use a patch the same thickness as the hull. just mic it. There is marine grade AL, but any good AL sheet will do. If the patches are small you might be able to get some from and Al farbication shop. A free scrap is good...usually means BSing for a half hour. BEAR
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options