The BaitShop Homepage
Forum Home Forum Home > FireArms, et cetera > Handguns, Pistols and SixGuns
  New Posts New Posts RSS Feed - project gun update
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

This site is completely supported by donations; there are no corporate sponsors. We would be honoured if you would consider a small donation, to be used exclusively for forum expenses.



Thank you, from the BaitShop Boyz!

Topic Closedproject gun update
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Triggerguard View Drop Down
.416 Rigby
.416 Rigby

aka The San Antonio Terminator

Joined: 13 June 2003
Location: United States
Status: Offline
Points: 2212 		Direct Link To This Post Topic: project gun update
    Posted: 02 May 2004 at 12:01
Polished down the worst of the pitting, but didn't want to change contours too much. Quite a change from the rust bucket I posted last week. I really like the epoxy coatings...easy to apply, look good, and wear well. Should make a nice plinker/truckgun.
"...A moral compass needs a butt end.Whatever direction France is pointing-towards collaboration with Nazis, accomodation with communists,...we can go the other way with a quiet conscience"-O'Rourke
Back to Top
Triggerguard View Drop Down
.416 Rigby
.416 Rigby

aka The San Antonio Terminator

Joined: 13 June 2003
Location: United States
Status: Offline
Points: 2212 		Direct Link To This Post Posted: 02 May 2004 at 12:04

Other side
"...A moral compass needs a butt end.Whatever direction France is pointing-towards collaboration with Nazis, accomodation with communists,...we can go the other way with a quiet conscience"-O'Rourke
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.070 seconds.